Eggtimer Rocketry Flight Computer Bedienungsanleitung PDF herunterladen (Seite 7)

Assembling your Eggfinder RX Board

Step 1: Sort the Components

Before you start soldering anything, you need to lay everything out and make sure that you are

familiar with all of components, and that you have everything. If you are missing something,

let us know immediately so we can send you whatever you need. You should have the

following parts, check them off as you sort them…

Qty Description

__ 1 Circuit board

__ 1 Hope RF HM-TRP-900 RF module

__ 1 LM1117-33MPX 3.3V voltage regulator

__ 1 3mm Red LED

__ 1 2.2K ohm 1/8 watt resistor (bands are red-red-red)

__ 1 10 uF electrolytic capacitor (tubular component with two wires,

one is marked “- - - - -“ on the side of the case)

__ 1 47 uF electrolytic capacitor (tubular component with two wires,

one is marked “- - - - -“ on the side of the case)

__ 1 USB-Serial Cable

__ 1 1/32” Brass Antenna wire (4”)

__ 1 3 ½” length of 1/16” heat-shrink tubing

__ 2 Small zip ties

__ 1 Coil of .020” 63/37 No-Clean solder wire

1 2 3 4 5 6 7 8 9 10 11 12 ... 16 17

Keine Kommentare

Eggtimer Rocketry Flight Computer Bedienungsanleitung Seite 7